## Lecture on Conversion of Units

Subject: Mathematic | Topics:

General purpose of this lecture is to present on Conversion of Units. Unit conversion is a multi-step process that involves multiplication or division by a numerical factor, selection of the correct number of significant digits, and rounding. Conversion of units Example: 1cm – 10mm; 1m – 100cm; 1km – 1000m etc. Volume is the volume of a three-dimensional figure is the amount of space within it. Capacity is the amount of material (usually liquid) that a container can hold. Capacity is measured in millilitres, litres and kilolitres.

### Vlasov Equation

Vlasov Equation is particularly important in studies of plasma waves, wave-particle interactions, and plasma instabilities. It is a differential equation describing time evolution of the distribution function of plasma consisting of charged particles with long-range interaction. Vlasov Equation a.....

### Monte Carlo Method

Monte Carlo method are a broad class of computational algorithms that rely on repeated random sampling to obtain numerical results. They are used in physical and mathematical problems and are most useful when it is difficult or impossible to use other mathematical methods. Monte Carlo method are .....

### Linear Equations

The aim of this lecture is to present on Linear Equations. Linear equations are functions which have two variables. They have an independent and dependent variable. Independent variables are variables that you put into the equations. Dependent variables are variables that you solve for. Just a.....

### Lecture on the Sine Rule

Major purpose of this lecture is to present on the Sine Rule. The Sine Rule is used to solve any problems involving triangles when at least either of the following is known: (a) two angles and a side and (b) two sides and an angle opposite a given side. We can use the sine rule when we are [&h.....

### Control Reconfiguration

Control Reconfiguration is required that the nominal controller remains part of the reconfigured control loop. It is to find a different set of actuators for controlling the plant and to use them in such a way that the plant output is identical to the output of the nominal closed-loop system. It .....